Canon imagePROGRAF iPF6400 User Guide - Page 731

iPF6400 Automatic Adjustment to Straighten Lines and Colors Adjustments for Better Print Quality • This function is not available with CAD Tracing Paper, CAD Translucent Matte Film, or CAD Clear Film. Important • If adjustment is not possible as expected using special media, try another type of paper, or try Manual adjustment. (See "Manual Adjustment to Straighten Lines and Colors.") →P.732 • Because the results of adjustment vary depending on the type of paper used for adjustment, use the same type of paper as Note you will use for printing. • If Standard does not improve printing, try adjusting the printhead manually. (See "Manual Adjustment to Straighten Lines and Colors.") →P.732 • If the printhead position was not adjusted during initial setup or when the printhead was replaced, execute Initial adjustmt. (See "Adjustment When Installing the Printhead.") →P.734 • Advanced adjustment can enable superior printing quality when printing fine lines or text at high precision on glossy or semi- glossy photo or proofing paper. (See "Enhancing Printing Quality.") →P.728 Items to Prepare When Using Rolls When Using Sheets An unused roll at least 254.0 mm (10.00 in) wide Standard : Six sheets of unused paper, A4/Letter size (or one sheet when using A2) Simple : One sheet of unused paper, A4/Letter size Perform adjustment as follows. 1 Load paper. • Loading Rolls on the Roll Holder →P.531 • Loading Rolls in the Printer →P.534 • Loading Sheets in the Feed Slot →P.554 • Always make sure the loaded paper matches the type of paper specified on the printer. Adjustment cannot be com- Important pleted correctly unless the loaded paper matches the settings. 2 On the Tab Selection screen of the Control Panel, press ◀ or ▶ to se- lect the Settings/Adj. tab ( ). Adjusting the Printhead • If the Tab Selection screen is not displayed, press the Menu button. Note 731 3 Press the OK button. The Set./Adj. Menu is displayed. User's Guide