Canon imagePROGRAF iPF6400 User Guide - Page 652

Control Panel Menu Settings Adjust Printer Head Posi. Adj. Setting Item Other Manual Feed Pri- Adj. Pri- ority ority Automatic Print Quality Print Length Adj. Quality Auto(GenuinePpr) Auto(OtherPaper) Manual Adjust Length AdjustmentPrint A:High B:Standard/Draft Change A:High Settings B:Standard/Draft Printer Menu Adj Far Ed Feed Calibra- Auto Adjust tion Calibration Log 652 iPF6400 Description, Instructions Input the setting values from the adjustment pattern printing results and adjust the printing position to fix misaligned printing. Normally, select Standard. However, when printing on special paper, or if printing is not improved after Standard, try Manual. (See "Manual Adjustment to Straighten Lines and Colors.") →P.732 Specify exact paper feeding, if desired. Normally, select Automatic. Choose Print Quality for attractive printing. Choosing Print Quality also makes banding less noticeable. Choose Print Length if you prefer to feed the paper an exact amount. However, note that slight banding may occur in the direction of carriage scanning when Print Length is selected. Specify this mode with paper identified in the Paper Reference Guide.(See Paper Reference Guide.) The printer prints and reads a test pattern for automatic adjustment of the feed amount. (See "Automatic Banding Adjustment.") →P.738 Specify this mode with paper not in the Paper Reference Guide.(See Paper Reference Guide.) The printer prints and reads a test pattern for automatic adjustment of the feed amount. Note that this function takes more time and consumes more ink than Auto(GenuinePpr). (See "Automatic Banding Adjustment.") →P.738 Use this mode with highly transparent media or other paper for which Auto(GenuinePpr) or Auto(OtherPaper) cannot be used. Print a test pattern for adjustment of the feed amount based on the type of paper. (See "Manual Banding Adjustment.") →P.739 Print a test pattern for particular types of paper to compensate for paper stretching or shrinkage, after which you enter the amount of adjustment. (See "Adjusting Line Length.") →P.742 Displayed when you have selected Feed Priority > Adj. Priority > Print Length. Adjustment relative to the amount of stretching or shrinkage of the current paper. Enter either the adjustment results from AdjustmentPrint or the discrepancy that you measured (as a percentage). For paper that tends to stretch, increase the feed amount by choosing a higher adjustment value. For paper that tends to shrink, decrease the feed amount by choosing a lower adjustment value. (See "Adjusting Line Length.") →P.742 Choose Yes to adjust the feed amount for the trailing edge. Execute color calibration. A test pattern for color calibration is printed and the adjustment values are set automatically. (See "Color Calibration Using the Printer Sensor.") →P.758 The Date, Paper Type, and Adjustment Type for which color calibration was executed are displayed on the Display Screen where you can confirm them. Common calibration and unique calibration are the Adjustment Type of color calibration. User's Guide