D-Link DCS-6511 Product Manual - Page 8

Preparing for Installation

Get D-Link DCS-6511 PDF manuals and user guides View all D-Link DCS-6511 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

Section 2 - Installation Preparing for Installation A. Depending on how you choose to mount the camera, you may need to change the orientation of the cable. For instance, when using the Surface Mounting Bracket, the cables may need to exit through the side of the camera base rather than the top. Changing Cable Orientation: 1. Disassemble the camera enclosure. (See Figure A on page 6.) 2. Loosen, but do not remove, the two screws that secure the camera bracket to the base of the enclosure using a screwdriver. (Figure 1.1) 3. Slide the camera bracket towards the front of the camera base. (Figure 1.2) Figure 1.1 4. Lift the camera bracket up and off from the camera base. (Figure 1.3) 5. Disconnect the cables from the connectors at the base of the camera. 6. Place the cable into the new hole and reconnect the cables to the cable connectors at the base of the camera. (Figure 1.4) Figure 1.2 D-Link DCS-6511 User Manual 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
8
D-Link DCS-6511 User Manual
Section 2 - Installation
Preparing for Installation
Figure 1.1
Figure 1.2
A. Depending on how you choose to mount the camera, you may need to change the
orientation of the cable. For instance, when using the Surface Mounting Bracket, the
cables may need to exit through the side of the camera base rather than the top.
Changing Cable Orientation:
1. Disassemble the camera enclosure. (See Figure A on page 6.)
2. Loosen, but do not remove, the two screws that secure the camera bracket to the
base of the enclosure using a screwdriver. (Figure 1.1)
3. Slide the camera bracket towards the front of the camera base. (Figure 1.2)
4. Lift the camera bracket up and off from the camera base. (Figure 1.3)
5. Disconnect the cables from the connectors at the base of the camera.
6. Place the cable into the new hole and reconnect the cables to the cable connectors
at the base of the camera. (Figure 1.4)