DIRECTV R10 System Manual - Page 98
Time Zone / Daylight Savings., Auto-Detect Satellite Information., Replace Access Card. - zoning
View all DIRECTV R10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
Chapter 6 88 Messages and Setup When you first come to this screen, it shows signal strength for the transponder that carries the current channel. If you are having trouble with a specific channel, tune to that channel, then come to this screen to check the signal for that transponder. • To change the transponder, use the UP arrow to highlight the transponder number. Press the RIGHT or LEFT arrow to change the transponder number. It is best if each transponder has a signal strength above 70. If you have an Oval, 2 or 3 satellite dish antenna, you can check the signal strength from transponders on each satellite. • To change the selected satellite, press the UP arrow until the satellite number is highlighted. Press the RIGHT or LEFT arrow to change the satellite. • Press the DOWN arrow to highlight the transponder number, then press the LEFT or the RIGHT arrow to check the signal on different transponders. If your signal strength is low, see "Satellite Signal Troubleshooting," on see page 24. Time Zone / Daylight Savings. DIRECTV sets the time on your DVR to be accurate at your billing address. If you temporarily move the DVR to a new location, you can change the time zone here. After changing the time zone, you can change the Daylight Savings setting. Auto-Detect Satellite Information. Only use this feature if directed to do so by a professional installer or a DIRECTV customer care representative. In most cases, you can use Repeat Guided Setup, rather than this option. Replace Access Card. If you need to replace your DIRECTV access card, follow the onscreen instructions. DIRECTV Central Messages & Setup Settings Satellite