Dell Dimension 4400 Dell Dimension 4400 Systems Owner's Manual - Page 80
Close the computer cover see
View all Dell Dimension 4400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
www.dell.com | support.dell.com HINT: Your computer uses cable-select drive cables. This means that the device connected to the end connector of the drive cable is the master device and the device connected to the middle connector is the slave device. Be sure that the jumper setting on the new device is set for "cable select" (see the documentation that came with the drive for information). 11 Locate the extra connector on the drive cable that is attached to your first hard drive and attach the connector to the second hard drive. power cable second hard-drive cable (secondary drive) first hard-drive cable (primary boot drive) 12 Close the computer cover (see page 87). 13 Connect your computer and devices to their electrical outlets, and turn them on. NOTICE: To connect a network cable, first plug the cable in to the network wall jack and then plug it in to the computer. 14 See the documentation that came with the drive for instructions on installing any software required for drive operation. 80 Adding Parts