Dell MXG610s Fibre Channel Switch Module Installation Guide May 2018 - Page 27
Static IP addresses
View all Dell MXG610s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Static IP addresses Dell EMC recommends configuring the switch module through the blade server chassis management GUI, namely, Dell EMC OpenManage Enterprise Modular. Use this management GUI to configure the switch IP address and perform advanced configuration tasks. By default, the IP address mode is set to DHCP. Use this GUI to assign a static IP address. To configure the FC switch module, follow these steps: 1 Log in to the blade server chassis management GUI application. Figure 9. OpenManage Enterprise modular 2 Select Devices > I/O modules. The I/O modules display. NOTE: You may also access the WebTools configuration UI to manage the switch module by typing the switch module IP address into any supported web browser. Figure 10. I/O modules list 3 Select the I/O module name, IP address, or View Details on the right side of the display. The Overview tab is displayed. Select the Settings tab. Figure 11. Settings tab 4 Click and expand the Network option. Select the required check boxes, and complete the IPv4 or IPv6 settings, DNS server settings, and optionally the management VLAN ID. Click Apply. Initial setup and verification 27