Dell PowerConnect 8100 CLI Reference Guide - Page 1252

Command Mode User EXEC, Privileged EXEC modes, Config mode and all Config sub-modes User Guidelines Some of the information below displays only if you enable OSPF and configure certain features. The following fields may be displayed: Field Description Router ID A 32-bit integer in dotted decimal format identifying the router about which information is displayed. This is a configured value. OSPF Admin Mode Shows whether OSPF is administratively enabled or disabled. RFC 1583 Compatibility This configuration option controls the preference rules used when choosing among multiple external LSAs advertising the same destination. When enabled, the preference rules remain those specified by RFC 1583. When disabled, the preference rules are those stated in Section 16.4.1 of RFC 2328. These rules prevent routing loops when external LSAs for the same destination have been originated from different areas. External LSDB Limit Shows the maximum number of non-default external LSAs entries that can be stored in the link-state database. Exit Overflow Interval Shows the number of seconds that, after entering OverflowState, as defined by RFC 1765, a router will attempt to leave OverflowState. Spf Delay Time The number of seconds to wait before running a routing table calculation after a topology change. Spf Hold Time The minimum number of seconds between routing table calculations. Flood Pacing Interval The average time, in milliseconds, between LS Update packet transmissions on an interface. This is the value configured with the timers pacing flood command. LSA Refresh Group Pacing Time The size of the LSA refresh group window, in seconds. This is the value configured with the timers pacing lsa-group command. Opaque Capability Shows whether router is capable of sending Opaque LSAs. 1252 OSPF Commands