Dell PowerConnect 8100 CLI Reference Guide - Page 1325

Exit Overflow Interval Shows the number of seconds that, after entering OverflowState, as defined by RFC 1765, a router will attempt to leave OverflowState. AutoCost Ref BW The configured autocost reference bandwidth. This value is used to determine the OSPF metric on its interfaces. The reference bandwidth is divided by the interface speed to compute the metric. Default Passive Setting When enabled, OSPF interfaces are passive by default. Maximum Paths Shows the maximum number of paths that OSPF can report for a given destination. Default Metric Default metric for redistributed routes. Default Route Advertise When enabled, OSPF originates a type 5 LSA advertising a default route. Always When this option is configured, OSPF only originates a default route when the router has learned a default route from another source. Metric Shows the metric for the advertised default routes. If the metric is not configured, this field is not configured. Metric Type Shows whether the metric for the default route is advertised as External Type 1 or External Type 2. Number of Active The number of OSPF areas to which the router is attached on Areas interfaces that are up. ABR Status Shows whether the router is an OSPF Area Border Router. ASBR Status Indicates whether the router is an autonomous system border router. Router automatically becomes an ASBR when it is configured to redistribute routes learned from another protocol. The possible values for the ASBR status is enabled (if the router is configured to re-distribute routes learned by other protocols) or disabled (if the router is not configured for the same). OSPFv3 Commands 1325