Dell PowerConnect 8100 CLI Reference Guide - Page 1331

Default Configuration This command has no default configuration. Command Mode User EXEC, Privileged EXEC mode, Config mode and all Config sub-modes show ipv6 ospf database Use the show ipv6 ospf database command in Privileged EXEC mode to display information about the link state database when OSPFv3 is enabled. If no parameters are entered, the command displays the LSA headers. Optional parameters specify the type of link state advertisements to display. The information below is only displayed if OSPF is enabled. Syntax show ipv6 ospf [area-id] database [{external | inter-area {prefix | router} | link | network | nssaexternal | prefix | router | unknown [area | as | link]}] [link-state-id] [adv-router [router-id] | self-originate] • area-id - Identifies a specific OSPF area for which link state database information will be displayed. • external - Displays the external LSAs. • inter-area - Displays the inter-area LSAs. • link - Displays the link LSAs. • network - Displays the network LSAs. • nssa-external - Displays NSSA external LSAs. • prefix - Displays intra-area Prefix LSA. • router - Displays router LSAs. • unknown - Displays unknown area, AS or link-scope LSAs. • link-state-id - Specifies a valid link state identifier (LSID). • adv-router - Shows the LSAs that are restricted by the advertising router. • router-id - Specifies a valid router identifier. • self-originate - Displays the LSAs in that are self originated. OSPFv3 Commands 1331