Dell PowerEdge M620 Hardware Owner's Manual - Page 213
Installing Memory Modules, WARNING
View all Dell PowerEdge M620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 213 highlights
Installing Memory Modules WARNING: The memory modules are hot to the touch for some time after the blade has been powered down. Allow time for the memory modules to cool before handling them. Handle the memory modules by the card edges and avoid touching the components. 1 Remove the blade. See "Removing a Blade" on page 155. 2 Open the blade. See "Opening the Blade" on page 159. 3 Locate the memory module sockets. See Figure 7-13 or Figure 7-12. 4 PowerEdge M910 and M905 systems only - You must slide the system board back in the blade chassis to access memory sockets (B1-B8) and (D1-D8) for M910 and (C1-C4) and (D1-D4) for M905. See step 1 through step 8 in "Removing the System Board" on page 276. 5 Press the ejectors on the memory module socket down and out, as shown in Figure 3-22, to allow the memory module to be inserted into the socket. If a memory module blank is installed in the socket, remove it. Figure 3-22. Installing and Removing a Memory Module or Memory Module Blank 2 1 1 memory module 3 ejectors (2) 5 alignment key 3 4 5 2 edge connector 4 socket Installing Blade Components 213