Dell PowerEdge M620 Hardware Owner's Manual - Page 264
Installing an HT Bridge Card, Because the system uses a ZIF processor socket, do not use force.
View all Dell PowerEdge M620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 264 highlights
Installing an HT Bridge Card 1 Perform the following steps to prepare the two sockets on the new system board: a Remove the processor filler blank. b Lift the plastic processor socket cover from the socket. c Unlatch and rotate the socket-release lever 90 degrees upward. d Lift the processor shield. e Repeat step a through step d to prepare the second processor socket. 2 Install the bridge card in the socket. See Figure 3-54. CAUTION: Positioning the card incorrectly can permanently damage the card and the system board when you turn the system on. Be careful not to bend the pins on the LGA socket. a Identify the pin-1 corner of the card by locating the tiny gold triangle on one corner of the card. Place this corner in the same corner of the ZIF socket identified by a corresponding triangle on the system board. b Ensure that the socket-release lever is fully open. c With the pin-1 corners of the card and socket aligned, set the processor lightly in the socket. Because the system uses a ZIF processor socket, do not use force. When the card is positioned correctly, it drops down into the socket with minimal pressure. d Close the processor shield. e Rotate the socket release lever down until it snaps into place, securing the card. 3 Close the blade. See "Closing the Blade" on page 161. 4 Install the blade. See "Installing a Blade" on page 158. 264 Installing Blade Components