Dell PowerEdge M620 Hardware Owner's Manual - Page 298
Installing an I/O Module, Enclosure Bezel, Removing the Enclosure Bezel
View all Dell PowerEdge M620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 298 highlights
Installing an I/O Module NOTE: The I/O module must be installed in the appropriate I/O bay. See "Guidelines for Installing I/O Modules" on page 52. 1 Unpack the I/O module and prepare it for installation. For instructions, see the documentation that accompanied the I/O module. 2 Remove the I/O connector cover from the back of the module. See Figure 4-6. 3 Install the I/O module in the M1000e enclosure: a Lift the handle release latch and open the I/O module handle. b Slide the module into the enclosure. c Close the handle until it snaps securely into place and the module is fully seated. 4 Connect all cables that must be attached to the I/O module. See the documentation provided with the I/O module for information about its cable connections. For more information on using the cable enumerators to organize and manage the cables, see the Rack Installation Guide. 5 A matching fabric mezzanine card must be installed in one or more blades to support the new I/O module. If necessary, install the mezzanine card(s) now. See "I/O Module Mezzanine Cards" on page 217. Enclosure Bezel Removing the Enclosure Bezel 1 Press the system power switch to turn off the system. See "System Control Panel Features" on page 16. 2 Rotate the LCD module so that the underside of the module faces upward. See Figure 4-11. 3 Remove the cable cover and disconnect the ribbon cable from the LCD module. 4 Remove the screws that secure the bezel to the enclosure. See Figure 4-7. 298 Installing Enclosure Components