Dell PowerEdge M620 Hardware Owner's Manual - Page 58
I/O Module Port Mapping, Full-Height Blades, Standard LOM (Dual-Port) Mapping, continued
View all Dell PowerEdge M620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Table 1-13. Supported I/O Module Configurations (continued) Fabric A Standard Integrated LOM Fabric B Mezzanine Card Fibre Channel mezzanine card Fabric C Mezzanine Card Ethernet mezzanine card I/O Bay A1, A2 Ethernet switch module or passthrough module I/O Bay B1, B2 Fibre Channel switch or passthrough module I/O Bay C1, C2 Ethernet switch module or passthrough module I/O Module Port Mapping The LOM and optional mezzanine cards are mapped to the I/O module ports based on the following rules. NOTE: The I/O port mappings in the following sections are applicable only to the I/O Pass-Through Modules. Full-Height Blades Standard LOM (Dual-Port) Mapping Each LOM has two port connections. For a full-height blade in bay n: • Integrated LOM1, connection 1 connects to I/O module A1, port n. Integrated LOM1, connection 2 connects to I/O module A2, port n. • Integrated LOM2, connection 1 connects to I/O module A1, port n+8. Integrated LOM2, connection 2 connects to I/O module A2, port n+8. For example, in a full-height blade in slot 5, integrated LOM1 connection 1 connects to I/O module A1, port 5 and LOM1 connection 2 connects to I/O module A2 port 5. LOM2 connection 1 connects to I/O module A1, port 13 and LOM2 connection 2 connects to I/O module A2, port 13. NOTE: Even though PowerEdge M610x is a full-height blade system, only one network controller (LOM1) is available. For PowerEdge M610x blade in bay n: • The integrated NIC connects to I/O module A1, port n and I/O module A2, port n 58 About Your System