Dell PowerEdge R760 Installation and Service Manual - Page 111

Figure 61. Installing a drive into the drive carrier Next steps 1. Install the drive carrier. Rear drive module Removing the 2 x 2.5-inch rear drive module Prerequisites 1. Follow the safety guidelines listed in Safety instructions. 2. Follow the procedure listed in Before working inside your system. 3. If required, remove the air shroud. 4. Remove the drives. 5. Disconnect the cables from the rear drive module. NOTE: Refer to cable routing section for more information. Table 76. Rear drive bay slot numbers Configurations with two rear drives Bay0 slot numbers 12 x 3.5-inch SAS/SATA + 2 x 2.5-inch SAS/ Slot 0 and 1 SATA 12 x 3.5-inch SAS/SATA + 2 x 2.5-inch NVMe Slot 0 and 1 24 x 2.5-inch SAS/SATA + 2 x 2.5-inch SAS/ N/A SATA 24 x 2.5-inch SAS/SATA + 2 x 2.5-inch NVMe Slot 0 and 1 Bay1 slot numbers N/A N/A Slot 24 and 25 N/A Steps 1. Using a Phillips #2 screwdriver, loosen the captive screws that secure the rear drive module to the system. 2. Press the blue release tab and holding the edges lift the rear drive module away from the system. Installing and removing system components 111