Dell PowerEdge R760 Installation and Service Manual - Page 112

Figure 62. Removing the 2 x 2.5-inch rear drive module Next steps 1. Replace the 2 x 2.5-inch rear drive module. Installing the 2 x 2.5-inch rear drive module Prerequisites 1. Follow the safety guidelines listed in Safety instructions. 2. Follow the procedure listed in Before working inside your system. 3. If required, remove the air shroud. 4. Remove the drives. 5. Disconnect the cables from the rear drive module. NOTE: Refer to cable routing section for more information. Steps 1. Align the slot on the rear drive module with the guide on the system. 2. Lower and press the rear drive module on top of the riser until firmly seated. 3. Using a Phillips #2 screwdriver, tighten the captive screws that secure the rear drive module into the system. 112 Installing and removing system components