Dell PowerEdge R760 Installation and Service Manual - Page 308
Installing the BOSS-N1 module blank, Upgrade Kits
![]() |
View all Dell PowerEdge R760 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 308 highlights
Figure 258. Installing the BOSS-N1 module blank To install the BOSS-N1 module: 1. To install the BOSS-N1 module , see installing the BOSS-N1 module steps 1 to 5. 2. To install the M.2 NVMe SSD and BOSS-N1 card carrier, see installing the BOSS-N1 module steps 6 to 10. NOTE: Install a BOSS-N1 card carrier blank if you are only using one BOSS-N1 card carrier. NOTE: Refer to cable routing section, configuration 49 and 50 for more information on connecting the BOSS cables to system board connectors. NOTE: The installation of the BOSS-N1 module to the Riser 1 and 4 x 2.5-inch rear drive module is similar. NOTE: Installing the BOSS-N1 card carrier does not require the system to be powered off. System shutdown is only required when installing the BOSS-N1 controller card module. 308 Upgrade Kits
![](/manual_guide/products/dell-poweredge-r760-installation-service-manual-8c03f25/308.png)