Dell PowerEdge R760 Installation and Service Manual - Page 300
Installing the LOM card and rear I/O board
![]() |
View all Dell PowerEdge R760 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 300 highlights
Installing the LOM card and rear I/O board Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in the Before working inside your system. 3. Remove the system board. NOTE: The procedure to install the liquid cooling rear I/O board and rear I/O board is the same. Steps 1. Align the connectors and slots on the LOM card or rear I/O board with the connector and standoffs on the system board. 2. Press the LOM card or rear I/O board until firmly seated on the system board connector. 3. Using a Phillips #2 screwdriver, secure the LOM card or rear I/O board to the system board with screws. Figure 251. Installing the LOM card and rear I/O board 300 Installing and removing system components
![](/manual_guide/products/dell-poweredge-r760-installation-service-manual-8c03f25/300.png)
Installing the LOM card and rear I/O board
Prerequisites
1.
Follow the safety guidelines listed in the
Safety instructions
.
2.
Follow the procedure listed in the
Before working inside your system
.
3.
Remove the system board
.
NOTE:
The procedure to install the liquid cooling rear I/O board and rear I/O board is the same.
Steps
1.
Align the connectors and slots on the LOM card or rear I/O board with the connector and standoffs on the system board.
2.
Press the LOM card or rear I/O board until firmly seated on the system board connector.
3.
Using a Phillips #2 screwdriver, secure the LOM card or rear I/O board to the system board with screws.
Figure 251. Installing the LOM card and rear I/O board
300
Installing and removing system components