Dell PowerSwitch S5212F-ON EMC SmartFabric OS10 User Guide Release 10.5.0 - Page 1249

discovery-interface Configures the interface to discover and connect to a VLT peer in the VLT interconnect (VLTi) link between peers. Syntax discovery-interface {ethernet node/slot/port[:subport]} Parameters ethernet - Enter the Ethernet interface information for the port on a VLT peer. You can also enter a range of interfaces separated by hyphens and commas. Default None Command Mode VLT-DOMAIN Usage Information The VLT node discovery service automatically connects the discovery port to its peer node port and creates VLTi interfaces. The no version of this command disables the discovery-interface configuration. NOTE: Dell EMC recommends that you disable flow-control on discovery interfaces. Use the no flowcontrol receive and no flowcontrol transmit commands to disable flow-control. Example OS10(config)# vlt-domain 1 OS10(conf-vlt-1)# discovery-interface ethernet 1/1/15 OS10(conf-if-eth1/1/15)# no flowcontrol receive OS10(conf-if-eth1/1/15)# no flowcontrol transmit Example (range) OS10(config)# vlt-domain 2 OS10(conf-vlt-2)# discovery-interface ethernet 1/1/1-1/1/2 OS10(conf-if-eth1/1/1)# no flowcontrol receive OS10(conf-if-eth1/1/1)# no flowcontrol transmit Supported Releases OS10(conf-if-eth1/1/2)# no flowcontrol receive OS10(conf-if-eth1/1/2)# no flowcontrol transmit 10.2.0E or later peer-routing Enables optimized routing where packets destined for the L3 endpoint of the VLT peer are locally routed. Syntax peer-routing Parameters None Default Disabled Command Mode VLT-DOMAIN Usage Information The no version of this command disables peer routing. Example OS10(conf-vlt-1)# peer-routing Supported Releases 10.2.0E or later peer-routing-timeout Configures the delay after which, the system disables peer routing when the peer is not available. This command supports both IPv6 and IPv4 routing. Syntax Parameters peer-routing-timeout value value - Enter the timeout value in seconds, from 0 to 65535. Virtual Link Trunking 1249