Dell PowerSwitch S5212F-ON EMC SmartFabric OS10 User Guide Release 10.5.0 - Page 73

Parameters None Default Not configured Command Mode All Usage Information Use the end command to return to EXEC mode to verify currently configured settings with show commands. Example OS10(config)# end OS10# Supported Releases 10.2.0E or later exit Returns to the next higher command mode. Syntax exit Parameters None Default Not configured Command Mode All Usage Information None Example OS10(conf-if-eth1/1/1)# exit OS10(config)# Supported Releases 10.2.0E or later hostname Sets the system host name. Syntax hostname name Parameters name - Enter the host name of the switch, a maximum of 64 characters. Default OS10 Command Mode CONFIGURATION Usage Information The host name is used in the OS10 command-line prompt. The MX7000 series switch, not the Dell EMC SmartFabric OS10, automatically sets the default hostname using a module-slot format. To calculate the hostname, the switch takes into account the module that is currently plugged into the MX7000 chassis and the slot in the chassis where the module is inserted. The module can be either MX9116n or MX5108n. NOTE: To make the switch automatically set the default hostname using the module-slot format, before upgrading to version 10.5.0, remove the user-defined hostname or set the default hostname using the no hostname command. Supported on the MX9116n and MX5108n switches in Full-Switch mode starting in release 10.4.0(R3S). Also supported in SmartFabric Services mode starting in 10.5.0. The no version of this command resets the host name to OS10. Example OS10(config)# hostname R1 R1(config)# CLI Basics 73