Dell PowerSwitch S5212F-ON EMC SmartFabric OS10 User Guide Release 10.5.0 - Page 299

▪ SFP+ unified ports operate in Ethernet 10GE mode by default. SFP+ unified ports support 4x8FC in FC mode. ▪ QSFP28 unified ports operate in Ethernet 100GE mode by default, and support 2x50G, 4x25G, and 4x10G breakouts. QSFP28 ports support 4x16GFC breakouts in FC mode. ▪ SFP+ Ethernet ports operate at 10GE. Usage Information • • • Setting a port group in 2x16GFC mode activates odd-numbered interfaces 1 and 3. A port group in 1x32GFC mode activates only interface 1. To display the current port profile on a switch, use the show switch-port-profile command. To change the port profile on a switch, use the switch-port-profile command with the desired profile, save it to the startup configuration and use the reload command to apply the change. The switch reboots with new port configuration. The no version of the command resets to the default profile. When a switch reloads with a new port profile, the startup configuration resets to system defaults, except for the switch-port profile and these configured settings: ○ Management interface 1/1/1 configuration ○ Management IPv4/IPv6 static routes ○ System hostname ○ Unified Forwarding Table (UFT) mode ○ ECMP maximum paths You must manually reconfigure other settings on a switch after you apply a new port profile and use the reload command to apply the change. Example OS10(config)# switch-port-profile 1/1 profile-1 Warning: Switch port profile will be applied only after a save and reload. All management port configurations will be retained but all other configurations will be wiped out after the reload. OS10(config)# do write memory OS10(config)# do reload Supported Releases 10.3.0E or later switchport access vlan Assigns access VLAN membership to a port in L2 Access or Trunk mode. Syntax switchport access vlan vlan-id Parameters vlan vlan-id - Enter the VLAN ID number, from 1 to 4093. Default VLAN 1 Command Mode INTERFACE Usage Information This command enables L2 switching for untagged traffic and assigns a port interface to default VLAN1. Use this command to change the assignment of the access VLAN that carries untagged traffic. You must create the VLAN before you can assign an access interface to it. The no version of this command resets access VLAN membership on a L2 access or trunk port to VLAN 1. Example OS10(conf-if-eth1/1/3)# switchport mode access OS10(conf-if-eth1/1/3)# switchport access vlan 100 Supported Releases 10.2.0E or later switchport mode Places an interface in L2 Access or Trunk mode. Syntax switchport mode {access | trunk} Interfaces 299