Dell PowerSwitch S5212F-ON EMC SmartFabric OS10 User Guide Release 10.5.0 - Page 35

Standby Partition: A Standby SW Version: 10.5.0EX Standby SW Build Version: 10.5.0EX.252 Standby Build Date/Time: 2019-07-27T17:31:55Z Next-Boot: active[B] 9. Reload the new software image in the standby partition in EXEC mode. OS10# reload 10. Use the show version command in EXEC mode to verify that the downloaded OS10 image is installed as the current running version. The running OS10 image is in the active partition. OS10# show version Dell EMC Networking OS10 Enterprise Copyright (c) 1999-2019 by Dell Inc. All Rights Reserved. OS Version: 10.5.0.0 Build Version: 10.5.0.270 Build Time: 2019-07-29T23:35:01+0000 System Type: S4148F-ON Architecture: x86_64 Up Time: 1 day 00:54:13 NOTE: When VLTi link is down, there should not be any configuration done in the VLT nodes. Doing so will result in mismatch of VLT configurations between the two nodes Install OS10 upgrade After you download and unpack a new OS10 binary image as described in Download OS10 image for upgrade, follow these steps: NOTE: During the OS10 image upgrade process in a VLT setup, when the VLT peers are running different software versions, make no configuration changes on a VLT peer. Ensure that both nodes are upgraded to the same version before you make any configuration change. NOTE: On an MX-Series I/O module, install OS10 upgrades in downloaded DUP files by following the instructions in the Dell EMC SmartFabric OS10 Release Notes-Release 10.5.0. NOTE: While performing an upgrade from 10.4.0E.R4S to 10.5.0.4 and later in GUI mode, all the IOMs may get upgraded with a time-out notification to the OME-M or an IOM (DNV Master) may not get upgraded. Check the IOMs to ascertain whether the upgrade was successful or not. If the IOMs did not get upgraded, re-initiate the upgrade for the impacted nodes. 1. (Optional) Back up the current running configuration to the startup configuration in EXEC mode. OS10# copy running-configuration startup-configuration 2. Back up the startup configuration (startup.xml) in EXEC mode. copy config://startup.xml ftp://userid:passwd@hostip/backup_filepath/10.5.0.4-startup.xml 3. Download the new OS10 binary image, also called the standby image, from a local server using the image download serverfilepath/filename command in EXEC mode; for example: OS10# image download sftp://admin:[email protected]/home/admin/images/OS10EE.bin 4. (Optional) View the current software download status in EXEC mode. OS10# show image status 5. Cancel any staged firmware update using the image cancel command. OS10# image cancel 6. Install the OS10 standby image using the image install file-url command in EXEC mode, where filename is the name of the image file downloaded in Step 3 with the image download command; for example: OS10# image install image://OS10EE.bin Getting Started with Dell EMC SmartFabric OS10 35