Dell PowerSwitch S5212F-ON EMC SmartFabric OS10 User Guide Release 10.5.0 - Page 128

1. Launch the Create Uplink for External Network Connectivity wizard. 2. Select the Uplink Connectivity as Layer 3. 3. Select the Network type as L3 VLAN. 4. Create a L3 VLAN uplink by providing the name and description, and click NEXT. NOTE: L3 uplinks can be created on leaf and spine switches. 5. Associate the interfaces of the spine or leaf switches with the L3 uplink. • Spine - Select a spine switch and an interface or multiple interfaces of the spine switch to be associated with the uplink. • Leaf - Select a leaf switch from the rack, and an interface or multiple interfaces of the leaf switch to be associated with the uplink. 6. Select the static or dynamic LAG based on the configuration setup in the external network, and click NEXT. 7. Create a L3 VLAN network by providing name, description, and VLAN ID, and associate to the selected interfaces. 8. Select if the network is a tagged or an untagged network. 9. Enter the IP address for the network. You can use the + symbol to add more IP addresses. 10. Define a routing policy to associate with the uplink based on the external network connectivity setup. • Static Route - A route policy template that contains a network prefix and the next hop IP address. • eBGP - A routing policy template that contains BGP peer IP address and the remote AS number. NOTE: The network configurations reflect in the switch only after associating the network with an uplink or server profile. From the SFS GUI Routing Profiles tab, you can view the list of all the routing profiles that are configured in the SFS. The page has two tabs: • ROUTE PROFILE - Displays detailed routing profile information. • PROFILE SWITCH MAPPING - Displays the list of profiles that are mapped to the switch. You can also delete a routing profile and profile switch mapping from the respective tabs. Select a profile from the tab, and click DELETE. Configure Layer 3 Routed uplink You can create a L3 Routed uplink and associate a network with the uplink. To do so: 1. Launch the Create Uplink for External Network Connectivity wizard. 2. Select the Uplink Ports Type as Layer 3. 3. Select the Network Type as L3 Routed. 4. Create a L3 Routed uplink by providing the name and description, and click NEXT. 5. Associate an interface from the spine or leaf switch with the L3 Routed uplink. • Spine - Select a spine switch and an interface from the spine to associate with the uplink. • Leaf - Select a leaf switch from the rack, and an interface from the leaf switch to associate with the uplink. NOTE: You can select only one interface from the spine or leaf switch for L3 Routed uplink. 6. Create a L3 Routed network to associate by providing a name, description, interface IP address, and prefix length. 7. Define a routing policy to associate with the uplink based on the external network connectivity setup. • Static Route - A route policy template that contains a network prefix and the next hop IP address. • eBGP - A routing policy template that contains BGP peer IP address and the remote AS number. NOTE: You cannot associate a L3 Routed network with more than one uplink or server profile. You can view and delete a routing profile from the Routing Profiles tab. Breakout Switch Ports wizard Breakout the speed of the physical Ethernet ports or port-group of the leaf switches, to connect to the external device or jump host. This wizard allows you to breakout Ethernet ports. To do so: 1. Launch the Breakout Switch Ports wizard. 2. Select the rack from the list. 3. Select the leaf switch in the rack. 4. Select a port-group or a physical Ethernet port of the leaf switch to breakout. 128 SmartFabric Services