Dell PowerSwitch S5212F-ON EMC SmartFabric OS10 User Guide Release 10.5.0 - Page 437

Configure advertise LLDP-MED network policies OS10(conf-if-eth1/1/5)# lldp med network-policy add 1 Change the fast start repeat count Fast start repeat enables a network-connectivity device to advertise itself at a faster rate for a limited amount of time. The fast start timer starts when a network-connectivity device receives the first LLDP frame from a newly detected endpoint. The LLDP-MED fast start repeat count specifies the number of LLDP packets that are sent during the LLDP-MED fast start period. By default, the device sends three packets per interval. The number of packets that are sent during activation ranges from 1 to10. Rapid availability is crucial for applications such as emergency call service location (E911). • Configure fast start repeat count which is the number of packets that are sent during activation in CONFIGURATION mode, from 1 to 10, default 3. lldp-med fast-start-repeat-count number Configure fast start repeat count OS10(config)# lldp med fast-start-repeat-count 5 LLDP commands clear lldp counters Clears LLDP and LLDP-MED transmit, receive, and discard statistics from all physical interfaces. Syntax clear lldp counters Parameters None Default Not configured Command Mode EXEC Usage Information The counter default value resets to zero for all physical interfaces. Example OS10# clear lldp counters Supported Releases 10.2.0E or later clear lldp table Clears LLDP neighbor information for all interfaces. Syntax clear lldp table Parameters None Default Not configured Command Mode EXEC Usage Information Neighbor information clears on all interfaces. Example OS10# clear lldp table Supported Releases 10.2.0E or later Layer 2 437