Dell PowerSwitch S5212F-ON EMC SmartFabric OS10 User Guide Release 10.5.0 - Page 316

Initiate the module replacement workflow To initiate the module replacement workflow, use the module replacement sfs_node_replace.py command from the master IOM. Enter the service tag information as the parameters in the module replacement command. You can find the service tag information in the Express Service Tag on the IOMs. To view the information, pull out the information tag in front of the system. Before initiating the workflow, the system prompts for the admin credentials. • Run the module replacement command from the Linux prompt. To display the service tag of an MX Ethernet I/O module, use the show smartfabric cluster member command in SmartFabric or Full Switch mode. admin@MX9116N-A2:~$ sfs_node_replace.py NewServiceTag oldServiceTag ○ NewServiceTag - Service tag of the new IOM ○ OldServiceTag - Service tag of the faulty IOM If the IOM is not part of the SmartFabric, the system displays the following error: Enter the Username for the Admin: admin Password: No Fabric found for specified nodes. Please recheck and issue this command again. Output example when you use the module replacement command in the master IOM: admin@MX9116N-A2:~$ sfs_node_replace.py JDB1XC2 68RRNK2 Enter the Username for the Admin: admin Password: % Total 100 142 % Received % Xferd Average Speed Time Time Time Current Dload Upload Total Spent Left Speed 100 89 100 53 646 384 649 Node replacement work-flow is initiated, the node JDB1XC2 will reboot into Fabric mode. After successful authentication, the system initiates the module replacement workflow and the new IOM reboots and is placed in the SmartFabric Services mode. Connect the new IOM After the switch reboots to the SmartFabric Services mode, connect all the cables as originally connected to the failed IOM. View SmartFabric Services configuration A SmartFabric is a network fabric that consists of physical resources, such as servers and switches and logical resources-networks, templates, and uplinks. SmartFabric Services is an OS10 feature enabled on PowerEdge MX Ethernet I/O modules. When you create a SmartFabric using the OpenManage Enterprise - Modular (OME-Modular) user interface, the switches assigned to the fabric are automatically placed in SmartFabric mode. In SmartFabric mode, PowerEdge MX switches operate as Layer 2 I/O aggregation devices with complete interoperability with all major network equipment vendors. Use the OME-Modular interface to configure PowerEdge MX networking in SmartFabric mode. For more information, see: • Dell EMC OpenManage Enterprise - Modular User's Guide, Ethernet IO Modules chapter • Dell EMC PowerEdge MX SmartFabric Services Configuration and Troubleshooting Guide You can enter SmartFabric Services show commands from the OS10 CLI to view SmartFabric configuration information. For more information, see SmartFabric commands. 316 PowerEdge MX Ethernet I/O modules