Dell PowerSwitch S5212F-ON EMC SmartFabric OS10 User Guide Release 10.5.0 - Page 602

Parameters • identifier as-num -Enter an AS number, from 0 to 65535 for 2 bytes, 1 to 4294967295 for 4 bytes, or 0.1 to 65535.65535 for dotted format. • peers as-number-Enter an AS number for peers in the BGP confederation, from 1 to 4294967295. Default Not configured Command Mode ROUTER-BGP Usage Information Configure your system to accept 4-byte formats before entering a 4-byte AS number. All routers in the Confederation must be 4-byte or 2-byte identified routers. You cannot have a mix of 2-byte and 4-byte identified routers. The autonomous system number that you configure in this command is visible to the EBGP neighbors. Each autonomous system is fully meshed and contains a few connections to other autonomous systems. The next-hop (MED) and local preference information is preserved throughout the confederation. The system accepts confederation EBGP peers without a LOCAL_PREF attribute. OS10 sends AS_CONFED_SET and accepts AS_CONFED_SET and AS_CONF_SEQ. The no version of this command deletes the confederation configuration. NOTE: To configure these settings for a nondefault VRF instance, you must first enter the ROUTER-CONFIG-VRF sub mode using the following commands: 1. Enter the ROUTER BGP mode using the router bgp as-number command. 2. From the ROUTER BGP mode, enter the ROUTER BGP VRF mode using the vrf vrf-name command. Example (Identifier) OS10(conf-router-bgp-2)# confederation identifier 1 Example (Peers) OS10(conf-router-bgp-2)# confederation peers 2 Supported Releases 10.3.0E or later client-to-client Enables route reflection between clients in a cluster. Syntax client-to-client {reflection} Parameters reflection - Enter to enable reflection of routes allowed in a cluster. Default Enabled Command Mode ROUTER-BGP Usage Information Configure the route reflector to enable route reflection between all clients. You must fully mesh all clients before you disable route reflection. The no version of this command disables route reflection in a cluster. NOTE: To configure these settings for a nondefault VRF instance, you must first enter the ROUTER-CONFIG-VRF sub mode using the following commands: 1. Enter the ROUTER BGP mode using the router bgp as-number command. 2. From the ROUTER BGP mode, enter the ROUTER BGP VRF mode using the vrf vrf-name command. Example OS10(conf-router-bgp-2)# client-to-client reflection Supported Releases 10.2.0E or later cluster-id Assigns a cluster ID to a BGP cluster with multiple route reflectors. Syntax cluster-id {number | ip-address} 602 Layer 3