Dell PowerSwitch S5212F-ON EMC SmartFabric OS10 User Guide Release 10.5.0 - Page 680

ip ospf passive Configures an interface as a passive interface and suppresses both receiving and sending routing updates to the passive interface. Syntax ip ospf passive Parameters None Default Not configured Command Mode INTERFACE Usage Information You must configure the interface before setting the interface to Passive mode. The no version of the this command disables the passive interface configuration. NOTE: As loopback interfaces are implicitly passive, the configuration to suppress sending and receiving of OSPF routing updates does not take effect on the loopback interfaces. However, network information corresponding to these loopback interfaces is still announced in OSPF LSAs that are sent through other interfaces configured for OSPF. Example OS10(conf-if-eth1/1/6)# ip ospf passive Supported Releases 10.2.0E or later ip ospf priority Sets the priority of the interface to determine the DR for the OSPF network. Syntax ip ospf priority number Parameters number - Enter a router priority number, from 0 to 255. Default 1 Command Mode INTERFACE Usage Information When two routers attached to a network attempt to become the DR, the one with the higher router priority takes precedence. The no version of this command resets the value to the default. Example OS10(conf-if-eth1/1/6)# ip ospf priority 4 Supported Releases 10.2.0E or later ip ospf retransmit-interval Sets the retransmission time between lost LSAs for adjacencies belonging to the interface. Syntax ip ospf retransmit-interval seconds Parameters seconds - Enter a value in seconds as the interval between retransmission, from 1 to 3600. Default 5 seconds Command Mode INTERFACE Usage Information Set the time interval to a number large enough to avoid unnecessary retransmission. The no version of this command resets the value to the default. Example OS10(conf-if-eth1/1/6)# ip ospf retransmit-interval 20 Supported Releases 10.2.0E or later 680 Layer 3