Dell PowerSwitch S5212F-ON EMC SmartFabric OS10 User Guide Release 10.5.0 - Page 681

ip ospf transmit-delay Sets the estimated time required to send a link state update packet on the interface. Syntax ip ospf transmit-delay seconds Parameters seconds - Set the time in seconds required to send a link-state update, from 1 to 3600. Default 1 second Command Mode INTERFACE Usage Information When you set the ip ospf transmit-delay value, take into account the transmission and propagation delays for the interface. The no version of this command resets the value to the default. Example OS10(conf-if-eth1/1/4)# ip ospf transmit-delay 5 Supported Releases 10.2.0E or later log-adjacency-changes Enables logging of syslog messages regarding changes in the OSPF adjacency state. Syntax log-adjacency-changes Parameters None Default Disabled Command Mode ROUTER-OSPF Usage Information The no version of this command resets the value to the default. Example OS10(config)# router ospf 10 OS10(conf-router-ospf-10)# log-adjacency-changes Supported Releases 10.2.0E or later max-metric router-lsa Configures OSPF to advertise a maximum metric on a router so that it is not desired as an intermediate hop from other routers. Syntax max-metric router-lsa Parameters None Default Not configured Command Mode ROUTER-OSPF Usage Information Routers in the network do not prefer other routers as the next intermediate hop after they calculate the shortest path. The no version of this command disables the maximum metric advertisement configuration. Example OS10(conf-router-ospf-10)# max-metric router-lsa Supported Releases 10.2.0E or later maximum-paths Enables forwarding of packets over multiple paths. Syntax Parameters Default Command Mode maximum-paths number number -Enter the number of paths for OSPF, from 1 to 128. 64 ROUTER-OSPF Layer 3 681