Dell PowerVault 130T DLT Service Manual - Page 77
Slide the motor up to align the holes., Place the Z belt over the Z motor shaft.
View all Dell PowerVault 130T DLT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
PowerVault 130T Service Manual Replacement 1. Insert the Z motor pulley through the cutout in the Z motor bracket so that the end of the pulley faces the front of the library. 2. Rest the pulley on the bottom of the cutout. The Z motor cable connector hangs toward the floor of the library. 3. Place the Z belt over the Z motor shaft. 4. Slide the motor up to align the holes. 5. Install the four screws holding the Z motor to the Z motor bracket using a Torx driver with a T-15 bit. Z Motor 4473D 3-41
PowerVault 130T Service Manual
Z Motor
4473D
3–41
Replacement
1.
Insert the Z motor pulley through the cutout
in the Z motor bracket so that the end of the
pulley faces the front of the library.
2.
Rest the pulley on the bottom of the cutout.
The Z motor cable connector hangs toward
the floor of the library.
3.
Place the Z belt over the Z motor shaft.
4.
Slide the motor up to align the holes.
5.
Install the four screws holding the Z motor
to the Z motor bracket using a Torx driver
with a T-15 bit.