Dell S510n Dell Interactive Projector S510/ Users Guide - Page 133
Power, Problem, Possible Solution, TEMP light is blinking
View all Dell S510n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 133 highlights
Problem (continued) LAMP light is blinking amber TEMP light is solid amber TEMP light is blinking amber The remote control is not operating smoothly or works only within a limited range Possible Solution (continued) If the LAMP light is blinking amber, the lamp module connection may be disrupted. Please check the lamp module and ensure that it is properly installed. If the LAMP lights and the Power light are blinking amber, the lamp driver has failed and the projector will automatically shut down. If the LAMP and TEMP lights are blinking amber and the Power light is solid blue, the color wheel has failed and the projector will automatically shut down. To clear the protection mode, press and hold the POWER button for 10 seconds. The projector has overheated. The display automatically shuts down. Turn the display on again after the projector cools down. If the problem persists, contact Dell. If the projector fan fails, the projector will automatically shut down. Try to clear the projector mode by pressing and holding the Power button for 10 seconds. Please wait for about 5 minutes and try to power up again. If the problem persists, contact Dell. The battery may be low. If so, replace with two new AAA batteries. Troubleshooting Your Projector 133