Dell Z9100 EMC Networking with Isilon Front-End Deployment and Best Practices - Page 70
Cluster Management > Network, Aggregation Mode
View all Dell Z9100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
2. After successfully logging into the OneFS web GUI, navigate to Cluster Management > Network Configuration. This will allow changes to the network configuration. 3. Select the More option next to groupnet0, and Add subnet. Define values for the next two subnets. Refer to Table 9. Subnet Configurations Parameter Value Subnet Name subnet1 Netmask 255.255.255.0 Gateway Address 172.16.1.254 MTU 9000(Jumbo Frame) SmartConnect Service IP 172.16.1.249 SmartConnect Service Name sczone1.dell.local Subnet Name subnet2 Netmask 255.255.255.0 Gateway Address 172.16.2.254 MTU 9000(Jumbo Frame) SmartConnect Service IP 172.16.2.249 SmartConnect Service Name sczone2.dell.local 4. Select the More option next to subnet1, and Add pool. 5. Define the pool name, pool1. 6. Set the IP range, 172.16.1.1-50. 7. Add in the 10gige-agg-1 interfaces for nodes 1-3 into the pool. 8. Set the SmartConnect Zone name, sczone1. 9. Set the SmartConnect Service subnet, subnet1. 10. Ensure that the Aggregation Mode is set to LACP. 11. Complete steps 4-10 to create pool2 in subnet2. 70 Dell EMC Networking with Isilon Front-End Deployment and Best Practices Guide | version 1.0