Denon AVR-5805CI Owners Manual - English - Page 101

2 Dolby Headphone recording • When REC OUT mode is set to "SOURCE", with the AVR5805CI it is possible to output signals encoded in the Dolby Headphone mode from the recording output terminal and record them on a separate recorder. 1 The Dolby Headphone play mode is set when headphones are connected to the PHONES jack during playback in the STANDARD (DOLBY/DTS Surround) mode. • When this is done, signals encoded in the Dolby Headphone mode are automatically output from the recording output terminals (analog and digital) and can be recorded. 2 Select the parameters and set the desired mode. • Start recording. Refer to the "Dolby Headphone" ( page 59). NOTE: • Do not disconnect the headphones during recording. Last Function Memory Advanced Operation Initialization of the Microprocessor • In very rare instances, the AVR-5805CI internal microprocessor might lock up, or otherwise cause mis-operation. This might be caused due to an AC line surge or line spike noise, or by static electric discharge on or nearby the unit, or to connected components. If the condition cannot be corrected by powering off the unit, including disconnection of the power supply cord for a period of ten minutes and subsequent re-connection, then the unit may have to be reinitialized. Doing so will restore the microprocessor to its original out-of-the-box state, with all custom memories and settings erased, and the original factory default settings restored. Only use this procedure if you are sure that the microprocessor requires re-initialization. 1 Switch off the unit using the main unit's POWER switch. 2 Hold the following STANDARD button and HOME THX CINEMA button, and turn the main unit's POWER switch on. 3 Check that the entire display is flashing with an interval of about 1 second, and release your fingers from the 2 buttons. • The microprocessor will be initialized. • This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediately before the power is switched off. This function eliminates the need to perform complicated resetting when the power is switched on. • The unit is also equipped with a back-up memory. This function provides approximately one week of memory storage from when the main unit's power switch is off and with the power supply cord disconnected. • If step 3 does not work, start over from step 1. • If the microprocessor has been reset, all the settings are reset to the default values (the values set upon shipment from the factory). 101