Denon AVR-5805CI Owners Manual - English - Page 150

Advanced Setup - Part 2 Setting the Direct Mode Setup • Set the ON/OFF setting of Room EQ, in the case of the surround mode is in DIRECT or PURE DIRECT. 1 Press the CURSOR D or H button to select "Direct Mode Setup" at the "Auto Setup / Room EQ" menu, then press the ENTER button. • The "Direct Mode Setup" screen appears. 2 Press the CURSOR F or G button to select "ON" or "OFF". 3 Press the ENTER button to enter the setting. • The "Auto Setup / Room EQ" menu reappears. Setting the MIC Input Select • Set this to switch the Mic Input jack for use for Mic jack or V.AUX L-channel input terminal. 1 Press the CURSOR D or H button to select "Mic Input Select" at the "Auto Setup / Room EQ" menu, then press the ENTER button. • The "Mic Input Select" screen appears. 2 Specifications and Setup Procedure for NonDENON Microphone Required Microphone for DENON Auto-Setup Room EQ : Product name Countryman B3 Required Microphone Amplifier Specification for DENON Auto- Setup Room EQ • Gain : 29 dB • Frequency Response : 10 ~ 30 kHz Full Flat (Ex : Rane MS1b) Microphone Placement • Set the microphone using microphone stand, or other method, at the prime listening position. • Point the top of the microphone toward the ceiling. • Adjust the height so that the top of microphone to matches the height of your ear when sitting. Microphone Amplifier Gain Setting using Sound Level Meter and RMS Volt Meter First you will need to adjust the " microphone amplifier gain". (1) Connect the all speakers and the video monitor (for the on screen display) with the AVR-5805CI. (2) Connect the microphone with the microphone amplifier. (3) Turn on the AVR-5805CI and the "microphone amplifier". (4) Turn on the "Phantom Supply" on the microphone amplifier. (5) Set the Parameter "Test Tone" to "Manual" and "Test Tone Start" to "Yes" at "Channel Level" ( page 143 ~ 145). (6) Once the test tone for Front Left (FL) speaker starts, check the Sound Pressure Level at the Listening Position with an SPL Meter. You do not have to check any of the other channels. (7) Adjust the "Main Volume" so that the Sound Pressure Level measures 80 dB (C-weighted). (8) Once the "Main Volume" as been set, connect the output of microphone amplifier to the RMS Volt Meter. (9) Adjust the "microphone amplifier's gain" as the RMS Volt Meter becomes about 120 [mV RMS]. (10) Once set, exit out of "System Setup" and turn off the AVR-5805CI. (11) Connect the output of the microphone amplifier to the AVR-5805CI's front panel "V.AUX" Left channel audio input-located behind Trap Door. (12) Change the setting to "V.AUX L" at "Mic Input Select". (13) Start "Auto Setup" ( page 20 ~ 26). 2 Press the CURSOR F or G button to select "Mic" or "V.AUX L". 3 Press the ENTER button to enter the setting. • The "Auto Setup / Room EQ" menu reappears. 150