Denon AVR-5805CI Owners Manual - English - Page 95

System setup for multi-zone • This makes possible to make the optimum setting for the speaker systems used in ZONE2. Advanced Operation 1 Select the ZONE2 mode using the AMP button. 2 Press the SYSTEM SETUP button. • The ZONE2 system setup menu appears. The screen displayed depends on the settings made at "Channel Setup" ( page 126 ~ 128). Example: When "ZONE2" is set for a 5.1 or 7.1 channel system 3 Press the CURSOR F or G button to adjust all the speakers to the same volume. 4 After completing the adjustment, press the TEST TONE button again. 2 Channel Level • After adjusting using the test tones, adjust the channel levels either according to the playback sources or to suit your tastes, as described below. Example: When "ZONE2" is set for a STEREO or MONO 1 Select the ZONE2 mode using the AMP button. 2 Press the CH SEL/ENTER button. • The "Channel Vol." screen appears. • For instructions on making the settings ( page 120 ~ 125). Adjustment steps that need to be performed prior to surround sound playback in ZONE2 2 Test Tone • Before playing with the surround function, be sure to use the test tones to adjust the playback level from the different speakers. This adjustment can be performed with the system setup ( page 122, 123) or from the remote control unit, as described below. • Adjusting with the remote control unit using the test tones is only possible in the "Auto" mode and only effective in the STANDARD (DOLBY/DTS SURROUND) modes. The adjusted levels for the different modes are automatically stored in the memory. 1 Select the ZONE2 mode using the AMP button. 2 Press the TEST TONE button. • The "Test Tone" screen appears. 3 Press the CURSOR D, H or CH SEL/ENTER button to select the speaker. The channel switches as shown below each time the CH SEL/ENTER button is pressed. FL C FR SW SR FADER SL SBL SBR ZONE2 surround back speakers are only displayed when "7.1ch" is selected for the ZONE2 channel output setting at "Channel Setup" ( page 126 ~ 128). When the ZONE2 surround back speaker setting is set to "1spkr" for "Speaker Configuration", this is set to "SB". 4 Press the CURSOR F or G button to adjust the level. The adjustment range for the different channels is +12.0 dB to -12.0 dB. The sound from the subwoofer can be completely cut by lowering the SW (subwoofer) setting one additional step from -12.0 dB (setting it to "OFF"). 95