Dewalt DCFS950P2 Instruction Manual - Page 16

English DCFS9501 Driver Blade Replacement Kit (Fig. N-P) WARNING: For your own safety, read the tool instruction manual before using any accessory. Failure to heed these warnings may result in serious personal injury and damage to the tool and the accessory. When servicing this tool, use only identical replacement parts. NOTICE: All the mechanical parts of the driver replacment kit are shown for convenience and verification of inclusion. To change a worn driver: 1. Using a T-20 Torx, loosen the four screws 17 on either side of the unit. Refer to Figure N. 2. Remove the four screws. Refer to Figure N. 3. Remove housing end cap 18 . Refer to Figure N. Fig. N 18 17 4. Push up on the rear of the driver 19 until you hear a click, then push the driver forward while holding it in this position until it passes the upper bumper assembly. Refer to Figure P. 5. Remove guide rods 20 . Refer to Figure O. 6. Remove upper bumper assembly 21 . Refer to Figure O. Fig. O 21 20 7. Lift the rear of driver until at an angle and pull the driver out. Refer to Figure P. 8. Replace driver and follow steps in reverse to reassemble 9. Ensure new driver slides smoothly through the gun before full reassembly. Fig. P 19 10. Return the driver, guide rods, bumpers and housing end cap back onto the unit. It is important to try the alignment of the driver and the flywheel before screwing the housing end cap back on to the unit. This can be done by connecting a battery and pushing then releasing the nose of the unit against a bench or hard surface. This will start the motor spinning. NOTE: When the driver and the flywheel are correctly aligned, you will hear the motor coast back down from full speed. If the driver and the flywheel are not correctly aligned, the motor may not start up, may slow down much faster than normal along with a loud grinding noise from the unit. If this happens remove and reseat the driver, making sure the bumpers are seated correctly. WARNING: Always test the unit by firing 1-1/2" (38 mm) staples in power setting 1 into scrap material, to ensure that the tool is working properly. If tool does not operate properly, contact a recognized DeWALT service center immediately. Recommended accessories for use with your tool are available at extra cost from your local dealer or authorized service center. If you need assistance in locating any accessory, please contact DeWALT Industrial Tool Co., 701 East Joppa Road, Towson, MD 21286, call 1-800-4-DeWALT (1-800-433-9258) or visit our website www.DeWALT.com. Repairs The charger and battery pack are not serviceable. WARNING: To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment (including brush inspection and replacement) should be performed by a DeWALT factory service center or a DeWALT authorized service center. Always use identical replacement parts. Register Online Thank you for your purchase. Register your product now for: • WARRANTY SERVICE: Registering your product will help you obtain more efficient warranty service in case there is a problem with your product. • CONFIRMATION OF OWNERSHIP: In case of an insurance loss, such as fire, flood or theft, your registration of ownership will serve as your proof of purchase. 14