Edimax EW-7438RPn Manual - Page 14

When a WPS connection has been successfully established, the Signal Strength LED will also light up in orange. Signal LED Note: If the WPS LED continues to blink in two-second intervals without moving on to Phase 2, then the Wi-Fi extender did not detect the WPS signal from the access point. Please return to step (2). If an error occurred, the WPS LED will flash rapidly. Please wait for the WPS LED to deactivate and try again from step (1). 5 minutes after a WPS connection has been established, the WPS LED will automatically deactivate. This is intended behavior. The WPS connection between the extender and the wireless access point will remain active. (3) Please move the extender to the location you wish to use it (a good place will be the center of your house) and insert this extender into a power outlet on the wall. The wireless connection to the root access point will be reestablished automatically. You can check the 'Signal' LED status to see the signal reception level. Steady light: Flashing: Flashing rapidly: Excellent Good Poor Note: If the Signal LED is off, it means this location is out of the wireless signal range of your wireless broadband router or access point, please move this extender clos1e2r to the broadband router until the extender can receive a signal from the broadband router and extend its signal.