Epson ActionPrinter 3250 User Manual - Page 21

Plugging in the Printer, Running the Self Test, CAUTION, Setting Up the Printer

Get Epson ActionPrinter 3250 - ActionPrinter-3250 Impact Printer PDF manuals and user guides View all Epson ActionPrinter 3250 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

Plugging in the Printer 1. Make sure the power switch on the printer is turned off. It is off when the side of the switch is pressed down. 2. Check the label on the back of the printer to make sure the voltage required by the printer matches that of your electrical outlet. CAUTION: If the rated voltage and your outlet voltage do not match, contact your dealer for assistance. Do not plug in the power cord. 3. If the power cord is not attached to the printer, connect it to the AC inlet on the printer. 4. Plug the power cord into a properly grounded electrical outlet. Running the Self Test You can run the self test with either continuous paper or single sheets; this section describes the easier way, with single sheets. 1-8 Setting Up the Printer

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
Plugging in the Printer
1.
Make sure the power switch on the printer is turned off. It is off
when the
side of the switch is pressed down.
2.
Check the label on the back of the printer to make sure the
voltage required by the printer matches that of your electrical
outlet.
CAUTION:
If the rated voltage and your outlet voltage do
not match, contact your dealer for assistance. Do not plug
in the power cord.
3.
If the power cord is not attached to the printer, connect it to the
AC inlet on the printer.
4.
Plug the power cord into a properly grounded electrical outlet.
Running the Self Test
You can run the self test with either continuous paper or single
sheets; this section describes the easier way, with single sheets.
1-8
Setting Up the Printer