Epson ActionTower 8200 User Manual - Page 142
The Computer Does Not Respond, The computer locks up., You reset the computer
![]() |
View all Epson ActionTower 8200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 142 highlights
If you replace the processor, make sure the new processor is installed correctly, and that the processor is aligned correctly on the system board. If you did not align it correctly, the system won't start. Also make sure the jumpers are set correctly for your processor speed. For more information, see "Installing Memory Modules (SIMMs)," "Upgrading the Processor," and "Changing the Jumper Settings" in Chapter 4 You may have installed option cards that exceed the system's power limits. Check "Option Slot Power Limits" in the Appendix to see if they exceed the option slot power limits of your computer. The Computer Does Not Respond The computer locks up. Wait a few moments; if your computer does not respond after a reasonable length of time, press Ctrl Alt Del and follow the instructions on the screen. If that doesn't work, press the RESET button. You may have installed memory using SIMMs that work at the wrong speed. Install the correct SIMMs; see "Installing Memory Modules (SIMMs)" in Chapter 4. Your system may have overheated. If you upgraded the processor yourself, make sure you have an adequate heat sink installed. You reset the computer, but it still does not respond. Try turning the computer off, wait 20 seconds, and turn it on again. Troubleshooting 7-5
![](/manual_guide/products/epson-actiontower-8000-user-manual-716f320/142.png)