Epson TM-m50II Technical Reference Guide - Page 107
Printing and Cutting Positions, Electrical Characteristics, Font A, 48 columns, ASCII character
View all Epson TM-m50II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 107 highlights
Printing and Cutting Positions Appendix Manualcutter position Autocutter position Approx. 9.5 mm {0.37"} Approx. 21.0 mm {0.83"} Center of the print dotline Paper feed direction • The values above may vary slightly as a result of paper slack or variations in the paper. Take this into account when setting the cutting position of the autocutter. • When removing cut paper, the remaining roll paper is pulled at the uncut section and the pitch of the next print may be reduced. When printing after cutting paper for prints with no pitch reduction, feed the paper about 1 mm {16/406 inches} before printing. When the Pre-feed before next print function is enabled, this operation is performed automatically. See"Software Settings" on page 50 for more details. Electrical Characteristics Operating voltage Current consumption (24V, 25°C, standard print density) Standby*1 Operating*2 DC +24 V±7% Mean: 0.1 A Mean: 1.8 A* *: When charging at 2.1A Note: When print ratio is approximately 18% • Continuous printing for 30 lines (repeating 20H-7FH) ∗ Font A, 48 columns, ASCII character • 5 lines feeding • Autocutting *1: The value is measured under our operating conditions. *2: The value is measured under our operating conditions without connecting peripheral devices to the printer. 107