Fujitsu 6000NS Operator's Guide - Page 153
are arbitrary, values between 0 and 255.
UPC - 097564307195
View all Fujitsu 6000NS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 153 highlights
3.6 Using the Network Settings Menus • If connection to LDAP server is not possible, try the following steps: HINT 1. Disconnect the LAN cable and turn the scanner off. 2. Reboot the scanner with the LAN cable disconnected, and enter a nonduplicate IP address. 3. Re-connect the LAN cable to the scanner. • If the DHCP server cannot be reached when DHCP is set to [On], the IP Address is set to "169.254.XXX.YYY" (where XXX and YYY are arbitrary values between 0 and 255). • If the status of the network connection is correct but the network is not communicating properly, change the [Link Speed/Duplex Mode] from "Auto-Negotiation" to a fixed mode. 3 Administrator Operations Network Scanner fi-6000NS Operator's Guide 125
3.6 Using the Network Settings Menus
Network Scanner fi-6000NS Operator's Guide
125
Administrator Operations
3
HINT
•
If connection to LDAP server is not possible, try the following steps:
1.
Disconnect the LAN cable and turn the scanner off.
2.
Reboot the scanner with the LAN cable disconnected, and enter a
nonduplicate IP address.
3.
Re-connect the LAN cable to the scanner.
•
If the DHCP server cannot be reached when DHCP is set to [On], the IP
Address is set to "169.254.
XXX
.
YYY
" (where
XXX
and
YYY
are arbitrary
values between 0 and 255).
•
If the status of the network connection is correct but the network is not
communicating properly, change the [Link Speed/Duplex Mode] from
"Auto-Negotiation" to a fixed mode.