Garmin GPSMAP 2206 GPSMAP 2206/2210 Owner's Manual - Page 12

Turning on the GPSMAP 2106/2110, Adjusting the Backlight - gps receiver

Page 12 highlights

GETTING STARTED > TURNING ON THE GPSMAP 2206/2210 Turning on the GPSMAP 2206/2210 Before you turn on the GPSMAP 2206/2210, make sure the unit and GPS 17 antenna are correctly installed on your vessel according to the instructions in the GPSMAP 2206/2210 & GPS 17 Installation Instructions. The first time you turn on the GPSMAP 2206/2210, the GPS 17 receiver must collect satellite data and determine its current location. To ensure proper initialization, the GPSMAP 2206/2210 is shipped from the factory in AutoLocate mode. To turn on the GPSMAP 2206/2210: 1. Press and hold the POWER key until the unit turns on. 2. When I Agree is highlighted on the Warning Page, press ENTER to open the Map Page. To turn off the GPSMAP 2206/2210: Press and hold the POWER key until the unit turns off. Adjusting the Backlight You can adjust the screen backlighting on the GPSMAP 2206/2210 from any page by using the POWER/BACKLIGHT key. To adjust the backlight level: 1. Press and release the POWER/BACKLIGHT key. 2. Press up on the ROCKER to increase the brightness, or press down to decrease. TIP: After you open the Backlight adjustment window, press the POWER/BACKLIGHT key repeatedly to cycle through the three backlight settings: Highest, Middle, and Lowest. NOTE: The first time you turn on the unit, you are asked if you want to start the retail demonstration. Select No, and press ENTER. 4 Highest Middle Lowest 3. Press ENTER or QUIT to close the Backlight adjustment window. GPSMAP 2206/2210 Owner's Manual

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106

4
GPSMAP 2206/2210 Owner’s Manual
G
ETTING
S
TARTED
>
T
URNING
ON
THE
GPSMAP 2206/2210
Turning on the GPSMAP 2206/2210
Before you turn on the GPSMAP 2206/2210, make sure the unit and GPS 17
antenna are correctly installed on your vessel according to the instructions in the
GPSMAP 2206/2210 & GPS 17 Installation Instructions
.
The first time you turn on the GPSMAP 2206/2210, the GPS 17 receiver
must collect satellite data and determine its current location. To ensure proper
initialization, the GPSMAP 2206/2210 is shipped from the factory in AutoLocate
mode.
To turn on the GPSMAP 2206/2210:
1.
Press and hold the
POWER
key until the unit turns on.
2.
When
I Agree
is highlighted on the Warning Page, press
ENTER
to open
the Map Page.
NOTE:
The first time you turn on the unit, you are asked if you want to start
the retail demonstration. Select
No
, and press
ENTER
.
To turn off the GPSMAP 2206/2210:
Press and hold the
POWER
key until the unit turns off.
Adjusting the Backlight
You can adjust the screen backlighting on the GPSMAP 2206/2210 from any
page by using the
POWER/BACKLIGHT
key.
To adjust the backlight level:
1.
Press and release the
POWER/BACKLIGHT
key.
2.
Press up on the
ROCKER
to increase the brightness, or press down to
decrease.
TIP:
After you open the Backlight adjustment window, press the
POWER/BACKLIGHT
key repeatedly to cycle through the three
backlight settings: Highest, Middle, and Lowest.
Highest
Middle
Lowest
3.
Press
ENTER
or
QUIT
to close the Backlight adjustment window.