Hayward HLPRO4 OmniPL-Automation-Operation-Manual-092786RevD - Page 16

Chlorinator If a chlorinator has been configured in the Configuration Wizard, you will see a chlorinator icon in the Features Screen. Touching this will bring you to the Chlorinator Control Screen which is shown below (your display may be different depending on the type of chlorinator chosen during configuration). Use this screen to enable/disable the chlorinator, set a schedule, super chlorinate and view/change diagnostics. A sample screen is shown below. For schedules, refer to the previous examples in this manual. 1 / 2 vsp pH alarm light row ON 15% 3200 ppm average SC heat/cool cleaner POOL features uclights chlorinator POOL chlorinator Enable / Disable - Slide this switch Set Schedule - Touch this to enable and disable the chlorinator button to set a schedule for and then touch the Save button. the chlorinator. Super Chlorinate - Touch this button to set the amount of hours that you'd like to super ON chlorinate. 15% 3200 ppm average SC Chlorinator Diagnostics - Touch this button to view diagnostics, set average salt, change polarity, and to reset the cell timer. POOL chlorinator Chlorinator Control Screen Change Setting- This slider will raise and lower the chlorinator setpoint setting. If an HL-CHEM is used and ORP is enabled, the adjustment will be displayed in "mV". If using an HL-CHEM - The Hayward HL-CHEM Sense and Dispense accessory continuously tests the pool's sanitization and pH levels allowing the to automatically generate/dispense the correct amount of chlorine and dispense the proper amount of pH reducer. If using the HL-CHEM and ORP has been enabled in the Configuration Wizard, the OmniPL will display chlorinator readings and settings in "mV" rather than "%". Refer to the following information+ as well as the HL-CHEM manual for configuration and operation instructions. 15 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS