Hayward HLPRO4 OmniPL-Automation-Operation-Manual-092786RevD - Page 19

pH Calibration If the OmniPL pH reading differs from independent water tests, you can adjust the reading by touching the Calibrate button and using procedure below. You'll be asked for the difference between the displayed pH level and the true pH level. You'll want to select the amount needed to go from the displayed level to the true level. In the example below, the displayed level is 7.3 and the true level is 7.5. You need to add .2 to the displayed level to arrive at the true pH level. Calibrate reading from 7.3 to 7.5 ON 7.5 Dispensing On 7.5 7.3 .2 7.3 .2 ON 7.3 Dispensing On 7.3 ColorLogic Lights You can set schedules for the ColorLogic light as well as a countdown timer. This procedure has been shown previously. Note that after the countdown interval, the lights will go off regardless of their previous state. 1 / 2 ON Dispensing On vsp pH alarm light row 7.3 7.3 heat/cool cleaner POOL features uclights chlorinator Light Show/Color - From the ColorLogic Control Screen, select the desired show or color. Use the Advance button to show all of the available selections. Use the Light Show/Color button to switch between all light shows and all solid colors. Synchronize - Because changing colors and shows requires interrupting power to the ColorLogic lights, there is a chance that the lights could lose synchronization due to timing issues. If you find that the color or show does not correspond with the selection that you've made, the lights may be out of sync. Touch the Synchronize button to re-sync the ColorLogic lights. 18 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS