HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 3 - IP Routing Configuration Gu - Page 107

The output shows that the DR and BDR are not changed, because the priority settings do not take effect immediately. 4. Restart OSPF process: # Restart the OSPF process of Switch D. reset ospf 1 process Warning : Reset OSPF process? [Y/N]:y # Display neighbor information of Switch D. display ospf peer verbose OSPF Process 1 with Router ID 4.4.4.4 Neighbors Area 0.0.0.0 interface 192.168.1.4(Vlan-interface1)'s neighbors Router ID: 1.1.1.1 Address: 192.168.1.1 GR State: Normal State: Full Mode: Nbr is Slave Priority: 100 DR: 192.168.1.1 BDR: 192.168.1.3 MTU: 0 Options is 0x02 E|-) Dead timer due in 39 sec Neighbor is up for 00:01:40 Authentication Sequence: [ 0 ] Router ID: 2.2.2.2 Address: 192.168.1.2 State: 2-Way Mode: None Priority: 0 DR: 192.168.1.1 BDR: 192.168.1.3 MTU: 0 Options is 0x02 E|-) Dead timer due in 35 sec Neighbor is up for 00:01:44 Authentication Sequence: [ 0 ] GR State: Normal Router ID: 3.3.3.3 Address: 192.168.1.3 GR State: Normal State: Full Mode: Nbr is Slave Priority: 2 DR: 192.168.1.1 BDR: 192.168.1.3 MTU: 0 Options is 0x02 E|-) Dead timer due in 39 sec Neighbor is up for 00:01:41 Authentication Sequence: [ 0 ] If the neighbor state is full, Switch D has established an adjacency with the neighbor. If the neighbor state is 2-way, the two switches are not the DR or the BDR, and they do not exchange LSAs. # Display OSPF interface information. [SwitchA] display ospf interface OSPF Process 1 with Router ID 1.1.1.1 Interfaces Area: 0.0.0.0 IP Address Type State Cost Pri DR BDR 96