HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 3 - IP Routing Configuration Gu - Page 35

Step Command 3. Specify a global RIP version. version { 1 | 2 } 4. Return to system view. 5. Enter interface view. quit interface interface-type interface-number 6. Specify a RIP version for the interface. rip version { 1 | 2 [ broadcast | multicast ] } Remarks By default, no global version is specified, and an interface sends RIPv1 broadcasts, and can receive RIPv1 broadcasts and unicasts, and RIPv2 broadcasts, multicasts, and unicasts. N/A N/A By default, no interface-specific RIP version is specified, and the interface sends RIPv1 broadcasts, and can receive RIPv1 broadcasts and unicasts, and RIPv2 broadcasts, multicasts, and unicasts. Configuring RIP route control Before you configure RIP route control, complete the following tasks: • Configure IP addresses for interfaces to ensure IP connectivity between neighboring routers. • Configure basic RIP. Configuring an additional routing metric An additional routing metric (hop count) can be added to the metric of an inbound or outbound RIP route. An outbound additional metric is added to the metric of a sent route, and it does not change the route's metric in the routing table. An inbound additional metric is added to the metric of a received route before the route is added into the routing table, and the route's metric is changed. If the sum of the additional metric and the original metric is greater than 16, the metric of the route is 16. To configure additional routing metrics: Step 1. Enter system view. 2. Enter interface view. 3. Specify an inbound additional routing metric. 4. Specify an outbound additional routing metric. Command system-view interface interface-type interface-number rip metricin [ route-policy route-policy-name ] value rip metricout [ route-policy route-policy-name ] value Remarks N/A N/A The default setting is 0. The default setting is 1. 24