HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 3 - IP Routing Configuration Gu - Page 72

Step 1. Enter system view. 2. Enter interface view. 3. Configure the OSPF network type for the interface as NBMA. 4. (Optional.) Configure a router priority for the interface. 5. Return to system view. 6. Enter OSPF view. Command system-view interface interface-type interface-number ospf network-type nbma ospf dr-priority priority quit ospf [ process-id | router-id router-id | vpn-instance vpn-instance-name ] * 7. Specify a neighbor and its peer ip-address [ cost value | router priority. dr-priority dr-priority ] Remarks N/A N/A By default, the network type of an interface depends on the link layer protocol. The default setting is 1. The router priority configured with this command is for DR election. N/A N/A By default, no neighbor is specified. The priority configured with this command indicates whether a neighbor has the election right or not. If you configure the router priority for a neighbor as 0, the local router determines the neighbor has no election right, and does not send hello packets to this neighbor. However, if the local router is the DR or BDR, it still sends hello packets to the neighbor for neighbor relationship establishment. Configuring the P2MP network type for an interface Step Command Remarks 1. Enter system view. system-view N/A 2. Enter interface view. interface interface-type interface-number N/A By default, the network type of an interface depends on the link layer protocol. 3. Configure the OSPF network After you configure the OSPF type for the interface as ospf network-type p2mp [ unicast ] network type for an interface as P2MP. P2MP unicast, all packets are unicast over the interface. The interface cannot broadcast hello packets to discover neighbors, so you must manually specify the neighbors. 4. Exit to system view. quit N/A 61