HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 3 - IP Routing Configuration Gu - Page 41

Step 1. Enter system view. 2. Enter RIP view. 3. Configure the maximum number of ECMP routes. Command system-view rip [ process-id ] [ vpn-instance vpn-instance-name ] maximum load-balancing number Remarks N/A N/A By default, the maximum number of ECMP routes is the same as that configured in the max-ecmp-num command. For more information about the max-ecmp-num command, see IP Routing Command Reference. Enabling zero field check on incoming RIPv1 messages Some fields in the RIPv1 message must be set to zero. These fields are called "zero fields." You can enable zero field check on incoming RIPv1 messages. If a zero field of a message contains a non-zero value, RIP does not process the message. If you are certain that all messages are trustworthy, disable zero field check to save CPU resources. This feature does not apply to RIPv2 packets, because they have no zero fields. To enable zero field check on incoming RIPv1 messages: Step 1. Enter system view. 2. Enter RIP view. 3. Enable zero field check on incoming RIPv1 messages. Command system-view rip [ process-id ] [ vpn-instance vpn-instance-name ] checkzero Remarks N/A N/A The default setting is enabled. Enabling source IP address check on incoming RIP updates Perform this task to enable source IP address check on incoming RIP updates. Upon receiving a message on an Ethernet interface, RIP compares the source IP address of the message with the IP address of the interface. If they are not in the same network segment, RIP discards the message. Upon receiving a message on a serial interface, RIP checks whether the source address of the message is the IP address of the peer interface. If not, RIP discards the message. To enable source IP address check on incoming RIP updates: Step 1. Enter system view. 2. Enter RIP view. Command system-view rip [ process-id ] [ vpn-instance vpn-instance-name ] Remarks N/A N/A 30