HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 3 - IP Routing Configuration Gu - Page 312

Tasks at a glance (Optional.) Tuning and optimizing OSPFv3 networks: • Configuring OSPFv3 timers • Specifying LSA transmission delay • Configuring a DR priority for an interface • Specifying SPF calculation interval • Specifying the LSA generation interval • Ignoring MTU check for DD packets • Disabling interfaces from receiving and sending OSPFv3 packets • Enabling the logging of neighbor state changes (Optional.) Configuring OSPFv3 GR: • Configuring GR Restarter • Configuring GR Helper (Optional.) Configuring BFD for OSPFv3 Enabling OSPFv3 Before you enable OSPFv3, configure IPv6 addresses for interfaces to ensure IPv6 connectivity between neighboring nodes. To enable an OSPFv3 process on a router: • Enable the OSPFv3 process globally. • Assign the OSPFv3 process a router ID. • Enable the OSPFv3 process on related interfaces. The router ID uniquely identifies the router within an AS. If a router runs multiple OSPFv3 processes, you must specify a unique router ID for each process. An OSPFv3 process ID has only local significance. Process 1 on a router can exchange packets with process 2 on another router. To enable OSPFv3: Step 1. Enter system view. 2. Enable an OSPFv3 process and enter its view. 3. Specify a router ID. 4. Enter interface view. 5. Enable an OSPFv3 process on the interface. Command system-view ospfv3 [ process-id | vpn-instance vpn-instance-name ] * router-id router-id interface interface-type interface-number ospfv3 process-id area area-id [ instance instance-id ] Remarks N/A By default, no OSPFv3 process is enabled. By default, no router ID is configured. N/A No OSPFv3 process is enabled on an interface by default. 301