HP 6125XLG R2306-HP 6125XLG Blade Switch MCE Configuration Guide - Page 38
Displaying information about IPv6 MCE, IPv6 MCE configuration example, Network requirements
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Step 5. Create and enter BGP IPv6 unicast instance view. Command ipv6-family [ unicast ] 6. Enable BGP to exchange IPv6 unicast routing information with peer ipv6-address enable the EBGP peer. 7. Redistribute VPN routes. import-route protocol [ process-id [ med med-value | route-policy route-policy-name ] * ] filter-policy { acl6-number | 8. (Optional.) Configure a filtering prefix-list ip-prefix-name } export policy to filter the routes to be [ direct | isisv6 process-id | ospfv3 advertised. process-id | ripng process-id | static ] 9. (Optional.) Configure a filtering policy to filter the received filter-policy { acl6-number | routes. ipv6-prefix ip-prefix-name } import Remarks N/A By default, BGP cannot exchange IPv6 unicast routing information with a peer. By default, no route redistribution is configured. By default, BGP does not filter the routes to be advertised. By default, BGP does not filter the received routes. NOTE: IPv6 BGP runs within a VPN in the same way as it runs within a public network. For more information about IPv6 BGP, see Layer 3-IP Routing Configuration Guide. Displaying information about IPv6 MCE Execute display commands in any view. Task Display information about a specific or all VPN instances. Display BGP peer group information for a VPN instance. Display BGP peer information for a VPN instance. Command display ip vpn-instance [ instance-name vpn-instance-name ] display bgp group ipv6 vpn-instance vpn-instance-name [ group-name ] display bgp peer ipv6 vpn-instance vpn-instance-name [ group-name log-info | ipv6-address { log-info | verbose } | verbose ] For commands that display information about a routing table, see Layer 3-IP Routing Command Reference. IPv6 MCE configuration example Network requirements As shown in Figure 6, the IPv6 MCE device is connected to VPN 1 through VLAN-interface 10 and to VPN 2 through VLAN-interface 20. RIPng is used in VPN 2. Configure the IPv6 MCE to separate routes from different VPNs and advertise VPN routes to PE 1 through OSPFv3. 35