HP 9000 Superdome SX2000 HP Installation Guide, HP Integrity Superdome/sx2000 - Page 29
Installing the Front Blower Bezel, Installing the Rear Blower Bezel
View all HP 9000 Superdome SX2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Figure 23 Installing the Rear Blower Bezel 3. Align the bezel over the nuts that are attached to the bracket at the rear of the cabinet. 4. Using a T-20 driver, tighten the two captive screws on the lower flange of the bezel. NOTE: Tighten the screws securely to prevent them from interfering with the door. 5. Close the cabinet rear door. Installing the Front Blower Bezel The front blower bezel is a cosmetic cover for the blowers and is located above the front door. To install the front blower bezel, follow these steps: 1. Open the front door. NOTE: The latch is located on the right side of the front door. 2. Position the bezel over the blower housing frame, hooking the lip of the bezel onto the cross support of the blower housing (Figure 24 (page 30)). Setting Up the System 29