HP 9000 Superdome SX2000 HP Installation Guide, HP Integrity Superdome/sx2000 - Page 55
Select Device, Power Switch: on, Power: enabled, Power Status First Window, <CR>
View all HP 9000 Superdome SX2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
1. To observe the power status, enter ps at the CM> prompt. A status screen similar to the one in Figure 51 appears. Figure 51 Power Status First Window 2. At the Select Device: prompt, enter b then the cabinet number to check the power status of the cabinet. Observe Power Switch: on and Power: enabled (Figure 52). Figure 52 Power Status Window Figure 52 shows that cells are installed in slots 0 and 4. In the cabinet, verify that cells are physically located in slots 0 and 4. 3. Press one more time to observe the power status (Figure 53). Booting and Verifying the System 55
1.
To observe the power status, enter
ps
at the
CM
> prompt. A status screen similar to the one
in
Figure 51
appears.
Figure 51 Power Status First Window
2.
At the
Select Device
: prompt, enter
b
then the cabinet number to check the power status
of the cabinet. Observe
Power Switch: on
and
Power: enabled
(
Figure 52
).
Figure 52 Power Status Window
Figure 52
shows that cells are installed in slots 0 and 4. In the cabinet, verify that cells are
physically located in slots 0 and 4.
3.
Press
<CR>
one more time to observe the power status (
Figure 53
).
Booting and Verifying the System
55